This specification arose from requirements to operate over HF Radio, which has exceedingly high latency (sometimes minutes) low data rates (down to 75 bits/second) and poor reliablity. STANAG 5066 [1] is a widely used HF link level protocol. Direct use of STANAG 5066 enables elimination of all extraneous end to end handshaking, which is important to optimize performance. It also enables use of STANAG 5066 flow control, which is important for resilience.
The solution uses the streaming service specified by SLEP [2] - SIS Layer Extension Protocol. SLEP specifies three layer services that operate over STANAG 5066, including a streaming service which provides an equivalent service to TCP. SLEP also provides compression, which is mandated for use by this specification.
The solution is based on Zero Handshake Server to Server Protocol (XEP-0361) [3] and requires peer configuration to be established according to XEP-0361. The data exchanged between the XMPP servers follows exactly what is specified in XEP-0361. The data is transferred using SLEP rather than using TCP.
This specification can be considered as a profile for server to server XMPP communication, to enable XMPP deployment over HF Radio using STANAG 5066. This profile MUST only be used where its use has been pre-agreed and configured for both participating servers.
An example scenario where this protocol is important is where two ships connected by HF Surface Wave communication only need to exchange XMPP messages. A reliable link (Soft Link) can be established using STANAG 5066 and XMPP communicated efficiently and reliably over SLEP.
Because of potentially very low bandwidth sending server MAY perform traffic optimisation, such as selective removal of stanzas that are not adding sufficient value, like CSNs, or strip selected elements such as xhtml-im.
Applications sending data over STANAG 5066 need to be aware of increased delays and any application level timers (e.g., IQ response timers) need to be set accordingly.
Stream Management (XEP-0198) [4] MAY be used over SLEP. Although reliability of stanza transfer is provided by use of STANAG 5066 and SLEP, use of Stream Management (XEP-0198) [4] is RECOMMENDED to monitor link latency.
Application-layer keepalives such as white-space pings are NOT RECOMMENDED.
The stanza stream is transferred using SLEP. SLEP compression is mandatory.
The peer addressing of the STANAG 5066 end points will be configured as part of the XEP-0361 peer agreement.
The STANAG 5066 SAP MAY be set to any mutually agreed value. It is RECOMMENDED that 6 is used which is the value specified in STANAG 5066 for use by this XEP.
Security Considerations of XEP-0361 apply. STANAG 5066 will frequently be employed in conjunction with link level crypto devices, which SHOULD be done when appropriate to provide data confidentiality.
This specification uses STANAG 5066 Edition 4 "TECHNICAL STANDARDS FOR HF RADIO LINK LAYER AND APPLICATION SUPPORT PROTOCOLS FOR SINGLE CHANNEL WAVEFORMS" (November 2021).
STANAG 5066 is a NATO UNCLASSIFED (Releasable to the Public) document that may circulated freely. It is available on https://www.isode.com/documentation/S5066Edition4ratification.pdf.
This specification uses the streaming service specified by SIS Layer Extension Protocol (SLEP) (S5066-APP3).
SLEP is an openly available protocol specification with no license restrictions. It is available on https://www.isode.com/whitepapers/S5066-APP3.html.
Curtis King designed and validated the original approach documented in this XEP.
Kevin Smith provided useful comments on this specification.
Dave Cridland asked NATO about STANAG 5066 publication, leading to its availability on the Web.
Edwin Mons implemented and validated the SLEP mapping.
This document in other formats: XML PDF
This XMPP Extension Protocol is copyright © 1999 – 2020 by the XMPP Standards Foundation (XSF).
Permission is hereby granted, free of charge, to any person obtaining a copy of this specification (the "Specification"), to make use of the Specification without restriction, including without limitation the rights to implement the Specification in a software program, deploy the Specification in a network service, and copy, modify, merge, publish, translate, distribute, sublicense, or sell copies of the Specification, and to permit persons to whom the Specification is furnished to do so, subject to the condition that the foregoing copyright notice and this permission notice shall be included in all copies or substantial portions of the Specification. Unless separate permission is granted, modified works that are redistributed shall not contain misleading information regarding the authors, title, number, or publisher of the Specification, and shall not claim endorsement of the modified works by the authors, any organization or project to which the authors belong, or the XMPP Standards Foundation.
## NOTE WELL: This Specification is provided on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, express or implied, including, without limitation, any warranties or conditions of TITLE, NON-INFRINGEMENT, MERCHANTABILITY, or FITNESS FOR A PARTICULAR PURPOSE. ##
In no event and under no legal theory, whether in tort (including negligence), contract, or otherwise, unless required by applicable law (such as deliberate and grossly negligent acts) or agreed to in writing, shall the XMPP Standards Foundation or any author of this Specification be liable for damages, including any direct, indirect, special, incidental, or consequential damages of any character arising from, out of, or in connection with the Specification or the implementation, deployment, or other use of the Specification (including but not limited to damages for loss of goodwill, work stoppage, computer failure or malfunction, or any and all other commercial damages or losses), even if the XMPP Standards Foundation or such author has been advised of the possibility of such damages.
This XMPP Extension Protocol has been contributed in full conformance with the XSF's Intellectual Property Rights Policy (a copy of which can be found at <https://xmpp.org/about/xsf/ipr-policy> or obtained by writing to XMPP Standards Foundation, P.O. Box 787, Parker, CO 80134 USA).
The HTML representation (you are looking at) is maintained by the XSF. It is based on the YAML CSS Framework, which is licensed under the terms of the CC-BY-SA 2.0 license.
The Extensible Messaging and Presence Protocol (XMPP) is defined in the XMPP Core (RFC 6120) and XMPP IM (RFC 6121) specifications contributed by the XMPP Standards Foundation to the Internet Standards Process, which is managed by the Internet Engineering Task Force in accordance with RFC 2026. Any protocol defined in this document has been developed outside the Internet Standards Process and is to be understood as an extension to XMPP rather than as an evolution, development, or modification of XMPP itself.
The primary venue for discussion of XMPP Extension Protocols is the <standards@xmpp.org> discussion list.
Discussion on other xmpp.org discussion lists might also be appropriate; see <https://xmpp.org/about/discuss.shtml> for a complete list.
Errata can be sent to <editor@xmpp.org>.
The following requirements keywords as used in this document are to be interpreted as described in RFC 2119: "MUST", "SHALL", "REQUIRED"; "MUST NOT", "SHALL NOT"; "SHOULD", "RECOMMENDED"; "SHOULD NOT", "NOT RECOMMENDED"; "MAY", "OPTIONAL".
1. STANAG 5066 C3B (EDITION 3): PROFILE FOR HF RADIO DATA COMMUNICATIONS <https://www.isode.com/documentation/S5066Edition4ratification.pdf>.
2. SIS Layer Extension Protocol (SLEP) (S5066-APP3) <https://www.isode.com/whitepapers/S5066-APP3.html>.
3. XEP-0361: Zero Handshake Server to Server Protocol <https://xmpp.org/extensions/xep-0361.html>.
4. XEP-0198: Stream Management <https://xmpp.org/extensions/xep-0198.html>.
Note: Older versions of this specification might be available at https://xmpp.org/extensions/attic/
Replace references to draft-ietf-xmpp-websocket with RFC7395 (XMPP over WebSocket).
Initial published version approved by the XMPP Council.
First draft.
@report{kille2015s5066,
title = {Server to Server communication over STANAG 5066 ARQ},
author = {Kille, Steve},
type = {XEP},
number = {0365},
version = {0.3},
institution = {XMPP Standards Foundation},
url = {https://xmpp.org/extensions/xep-0365.html},
date = {2015-08-19/2022-03-28},
}END